carson
Well-known member
In another post I described the basic problem. Went on to explain the importance of clean connectors leading to the LED read-out. By resolving the connector problem I proved that the LED read-out is functioning properly.
However, I still have the same problem. The tank is less than 1/2 full; the readout reads near full. I presume that the the sensor/ rheostat on the tank is not performing its expected duty. It has two wires attached.
My question: Where do I start to a) find a sensor on the web? not much luck in searching.
Has anyone here replaced the indicator? What is involved in doing that? How does the sensor work? Float?
I know it is a minor inconvenience, the needle reads ok but not the LED.
I have run out of things to fix on the rig, gotta look for something. ;D
carson FL
However, I still have the same problem. The tank is less than 1/2 full; the readout reads near full. I presume that the the sensor/ rheostat on the tank is not performing its expected duty. It has two wires attached.
My question: Where do I start to a) find a sensor on the web? not much luck in searching.
Has anyone here replaced the indicator? What is involved in doing that? How does the sensor work? Float?
I know it is a minor inconvenience, the needle reads ok but not the LED.
I have run out of things to fix on the rig, gotta look for something. ;D
carson FL