Recent content by Jjenkins5179

All wires coming from the battery bank and to the inverter are 4/0. The wire in question is 10 inches in length. The neg/pos wire from the battery bank to the fuse holder/shunt are both approximately 26 inches in length (that measurement includes the fuse holder for the positive).

Well, I think my switch might have something to do with the issue. I put my multimeter on it and regardless if the switch is on or off current is still passing through it. So I’m wondering if it’s not allowing the full current that is being called for to flow through the switch causing 1) the...

This would be temporary, if the switch is bad I would still have it hooked up after the test so I could disconnect the system if need be until a new switched could be obtained.

Thoughts on bypassing the disconnect switch, going from the 4/0 wire coming from the ANL fuse holder directly to the Lynx Distributor, just to see if it is the switch? That wire has shown signs of getting very warm and I’m wondering if the switch has gone bad and is not allowing the full current...

When we start the Keurig about 3 seconds in we have total power loss of everything. Few seconds later power come back, I get a low battery warning on the Victron App. By Significant power i am referring to the power draw from the Keurig, the same thing happens if we try the microwave, which has...

Hey everyone. Looking for some assistance/guidance. I have a setup that was intended to allow my wife to brew a cup of coffee when we were dry camping/boondocking. I have 4 Battle Born 100 Ah, 12V batteries, a Victron 12/3000/120-50 2 x 120v Charger/inverter. Batteries are wired in parallel with...